Here are pictures of a Seven Ten Model 710C reel. It appears to be unused and new in the box. It pretty much comes with the recognized gearing, anti-reverse, and drag system. It does come with the rubber washer rather than the metal one under the drag knob. It has an interesting raised marking on the front side of the main frame line spool housing area. I am not sure what it is supposed to be or represent. Also the nut that holds the rotor on the shaft has a neck that extends down inside the rubber line snubber that fits on the front of the rotor. Finally when I took the reel apart to clean out the factory grease that tends to harden, I noticed what I thought appeared to be the pinion gear installed incorrectly at least in my mind (see the picture). I assumed the flat washer like end on the gear would rest against the main frame housing. So when I reinstalled it, I put the flat end there. But when I turned the handle, there was a slight chatter to the gears. So I reinstalled it like it came and the chatter went away. Looks weird to me but I guess that is how it is supposed to be. I will post pictures of the owner’s manual to that thread. It proves you can’t rely on pictures because some of the parts they picture in it, (i.e. front cover and rotor nut) don’t match what the actual parts look like.